pickbad.blogg.se - Install kerio vpn client ubuntu

Kerio Connect Webadmin portal loads successfully.Kerio IPsec Internet Protocol security - A network protocol used to encrypt and secure data sent over a network.

Successful completion of the installation can be verified by the following:

Follow the steps shared by the installation wizard to perform the initial configuration of Kerio Connect.

Open the URL: If this prompts you with the warning: Your connection is not private, click the Advanced button and proceed to the link.

Reload the firewall for changes to take effect using this command: firewall-cmd -reload.

Replace the zone value and run this command for all active zones. Note: This command is an example when the zone is public. Run the following command for each active zone: firewall-cmd -zone= public -add-port=4040/tcp -permanent

The outcome lists your active zones (public, DMZ, etc.).

Run this command to retrieve active zones: firewall-cmd -get-active-zones.

Configure the CentOS firewall using the steps given below for allowing the remote administration (through port 4040) and protocols of Kerio Connect:.

If the installation is successful, the active status displays as Active (running), as seen in the screenshot below:

Check the status of Kerio Connect service using the command: systemctl status kerio-connect.

Once the installation completes, an output similar to the following displays as the confirmation:

Install Kerio Connect using the following command: sudo yum install kerio-connect-9.2.10-4692-linux-x86_64.rpm.

Use the following commands to disable and stop the postfix service to the Kerio Connect installation without interference:.

Check the status of postfix using the command systemctl status postfix as shown in the screenshot below:.

You can also use the WGET tool to download.

Download the latest version of Kerio Connect for RPM-based systems.

Enable the Apply security policy in the process, as shown below:.

Install CentOS 7 (subversion 7.6 or above) using the official step-by-step guide.

Note: This process was tested on the sub-version CentOS 7.6 and is expected to be the same for all higher sub-versions (7.7 and above). This article shares the process of installing Kerio Connect on the CentOS 7 operating system.